Galaxy Flex Installer Manual Connect outputs19If the keyswitch is spring-loaded (returns to its normal position), the transition from 1 kΩ to2 kΩ initiates the setting procedure of an unset system and instantly unsets a set system, thetransition from 2 kΩ to 1 kΩ – the return to the normal position - has no effect. This isprogrammed as a Keyswitch in the Program Zones [52] option.Wire terminator buttonsZones programmed as Push-Set (terminator) buttons can be open going closed (2 kΩ to1 kΩ) or closed going open (1 kΩ to 2 kΩ). The first activation of the terminator buttoninitialises its status to the system.Note: The first activation of a terminator may not set the system as this can be theinitialisation routine. If the system continues setting, push the button again. Thesystem will set on the second push. This initialisation only occurs on the first setting.All subsequent setting routines set on the first push of the terminator.The wiring of the terminator and keyswitch zone type is shown in the following figure:Figure 7 Terminator and keyswitch zone wiringConnect outputsOutputs are addressed in the same way as the zones. If using onboard outputs, connect andaddress as follows:O/P Address Function O/P type Connection1 1001 Bells Open-collector,switched negativeConnect load between OP1and +12 V2 1002 Strobe Open-collector,switched negativeConnect load between OP2and +12 V3 99 Exit/Entry (E/E) horn AC audio to drive aninternal loudspeakerConnect load (8–32 Ω)between OP3 and +12 VIf required, use the Program Outputs menu (53 ent) to modify the default settings.
