Chapter 4 Sending Faxes With the MultiPASS L6000 4-7m If there is no group registered under the one-touch speeddialing button or the two-digit code, the LCD displays theNO TEL # message. Make sure you entered the correctnumber and that the group has been registered correctly toa speed dial code. See page 3-20.m If you make a mistake when dialing, press STOP. You cantry again.RedialingManualTo start dialing again, just press the REDIAL/PAUSE button. TheMultiPASS redials the previous number you dialed with the numericbuttons. Make sure the document is in the ADF.AutomaticThe MultiPASS automatically redials if the first attempt at sending fails(for example, if the line is busy). The unit redials twice, and the timebetween redials is two minutes. (These are the default settings.) The LCDdisplays AUTO REDIAL and the transaction number while the MultiPASS isredialing.If the MultiPASS fails to make a connection after the last redial, it beeps.The LCD displays BUSY/NO SIGNAL; try sending again later.You can change the number of redials and the time between redials. Theredialing options are set in the Send Fax dialog box of the MultiPASSDesktop Manager; see page 8-4.BUSY/NO SIGNALTX/RX NO. XXXXAUTO REDIALSending Faxes
