vUSERS IN CANADAPRE-INSTALLATION REQUIREMENTS FOR CANONFACSIMILE EQUIPMENTA. LocationSupply a suitable table, cabinet, or desk. See Appendix A for the unit’sdimensions and weight.B. Order Information1. Provide only a single-line to touch-tone or rotary telephone setterminated with a standard 4-pin modular phone plug. (Touch-tone isrecommended if available in your area.)2. Order an RJ11-C modular jack (USOC code), which should be installedby the phone company. If the RJ11-C jack is not present, installationcannot occur.3. Order a normal business line from your telephone company’s businessrepresentative. The line should be a regular voice grade line or equivalent.Use one line per unit.DDD (DIRECT DISTANCE DIAL) LINEorIDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IFYOU COMMUNICATE OVERSEASN Canon recommends an individual line following industry standards [e.g., the 2500(touch-tone) or 500 (rotary/pulse dial) telephones]. A dedicated extension off aPBX unit without “Camp On” signals is also permissible with your MultiPASSL6000. Key telephone systems are not recommended because they send non-standard signals to individual telephones for ringing and special codes, which maycause a fax error.C. Power RequirementsThe power outlet should be a three-prong grounded receptacle (Single orDuplex). It should be independent from copiers, heaters, air conditioners, orany electric equipment that is thermostatically controlled. The rated value is120 volts and 15 amperes. The RJ11-C modular jack should be relativelyclose to the power outlet to facilitate installation.NOTICEThe Industry Canada label identifies certified equipment. This certification meansthat the equipment meets telecommunications network protective, operational andsafety requirements as prescribed in the appropriate Terminal EquipmentTechnical Requirements document(s). The Department does not guarantee theequipment will operate to the user’s satisfaction.
