H3C SR8800 Command Reference Manual

Also see for SR8800 IM-FW-II: Configuration guide Manual

Contents

H3C SR8800 Command Reference Manual Manual pdf 74 page image

66in status enquiry = 0, out status = 0status enquiry timeout = 0, discarded messages = 0Table 13 Output descriptionField DescriptionFrame relay LMI statistics for interfaceSerial4/1/8:10(DTE, Q933)Terminal type and LMI protocol type for the frame relayinterfaceT391DTE = 10 (hold timer 10) DTE-side T.391 settingN391DTE = 6, N392DTE = 3, N393DTE = 4 DTE-side N.391, N.392, and N.393 settingsout status enquiry = 96, in status = 85Number of the Status-Enquiry packets sent out through theinterface and that of the Status messages received through theinterfacestatus timeout = 3, discarded messages = 3 Number of the Status messages that are timed out and that ofthe discarded messagesFrame relay LMI statistics for interfaceSerial4/1/10:10 (DCE, Q933)Serial2/0 (a frame relay interface) is a DCE interfaceconformed with the standard described in Q.933 appendix AT392DCE = 15, N392DCE = 3, N393DCE =4 The T392, N392, and N393 parameters of the DCE interfacein status enquiry = 0, out status = 0Number of the Status-Enquiry messages received through theinterface and that of the Status messages sent out through theinterfacestatus enquiry timeout = 0, discardedmessages = 0Number of the Status-Enquiry messages that are timed out andnumber of the discarded messagesdisplay fr map-infoSyntaxdisplay fr map-info [ interface interface-type { interface-number | interface-number.subnumber } ] [ |{ begin | exclude | include } regular-expression ]ViewAny viewDefault level1: Monitor levelParametersinterface interface-type { interface-number | interface-number.subnumber }: Specifies an interface by itstype and number. It can be a main or subinterface. The interface-number argument is a main interfacenumber. The subnumber argument is a subinterface number, in the range 0 to 1023.|: Filters command output by specifying a regular expression. For more information about regularexpressions, see Fundamentals Configuration Guide.begin: Displays the first line that matches the specified regular expression and all lines that follow.exclude: Displays all lines that do not match the specified regular expression.include: Displays all lines that match the specified regular expression.