H3C SR8800 Command Reference Manual

Also see for SR8800 IM-FW-II: Configuration guide Manual

Contents

H3C SR8800 Command Reference Manual Manual pdf 60 page image

52Default level2: System levelParametersnumber: Maximum number of selected member interfaces. The value range for this argument is 1 to 8.DescriptionUse the bundle max-active links command to limit the number of selected interfaces in an HDLC linkbundle.Use the undo bundle max-active links command to remove the limit.By default, no limit is set on the maximum number of selected member interfaces in an HDLC link bundle.The value specified using this command cannot be smaller than that specified using the bundlemin-active links command.Use the bundle max-active links command together with the bundle member-priority command to makesure that the peer interfaces of a link always have the same selected status. If one end is selected but theother end is unselected, communication failure will occur.Related commands: bundle min-active links and bundle member-priority.Examples# Limit the number of selected member interfaces in HDLC link bundle 1 to 8. system-view[Sysname] interface Hdlc-bundle 1[Sysname-Hdlc-bundle1] bundle max-active links 8bundle member-prioritySyntaxbundle member-priority priorityundo bundle member-priorityViewPOS interface viewDefault level2: System levelParameterspriority: Bundling priority of an HDLC link bundle member interface. The value range for this argumentis 1 to 65535.DescriptionUse the bundle member-priority command to set the bundling priority of an HDLC-enabled POSinterface.Use the undo bundle member-priority command to restore the default.The default bundling priority of an HDLC-enabled POS interface is 32768.A higher priory value equals a lower bundling priority.