4display atm map-infoSyntaxdisplay atm map-info [ interface atm { interface-number | interface-number.subnumber } [ pvc{ pvc-name [ vpi/vci ] | vpi/vci } ] ] [ | { begin | exclude | include } regular-expression ]ViewAny viewDefault level1: Monitor levelParametersinterface-number: Number of an ATM main interface.interface-number.subnumber: Number of an ATM subinterface, in the range of 0 to 1023.interface-number is the number of the ATM main interface.pvc-name: PVC name, a unique case-insensitive string of 1 to 16 characters on the specified ATMinterface. The name cannot be the same as any valid VPI/VCI pair. For example, the name 1/20 is notallowed.vpi/vci: VPI/VCI pair. VPI is short for virtual path identifier; its value ranges from 0 to 255. VCI is shortfor virtual channel identifier; its value ranges from 0 to 1023. Because VCIs from 0 to 31 are reserved forspecial purposes, do not use them in normal cases.|: Filters command output by specifying a regular expression. For more information about regularexpressions, see Fundamentals Configuration Guide.begin: Displays the first line that matches the specified regular expression and all lines that follow.exclude: Displays all lines that do not match the specified regular expression.include: Displays all lines that match the specified regular expression.regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.DescriptionUse the display atm map-info command to display the PVC mappings on the specified ATM maininterface, subinterface, PVC, or all ATM interfaces if no interface is specified.Examples# Display the PVC mappings on all ATM interfaces. display atm map-infoAtm3/1/1, PVC 10/47, ETH, Virtual-Ethernet3/0/1, UPAtm3/1/1, PVC 10/48, ETH, Virtual-Ethernet3/0/1, UPAtm3/1/2, PVC 10/100, IP, State UP100.11.1.1, vlink 327752Table 2 Output descriptionField DescriptionATM3/1/1 Interface numberPVC 10/47 PVC identifierIP/ETH Protocol type