H3C SR8800 Command Reference Manual

Also see for SR8800 IM-FW-II: Configuration guide Manual

Contents

H3C SR8800 Command Reference Manual Manual pdf 59 page image

51HDLC link bundling configuration commandsbundle idSyntaxbundle id bundle-idundo bundle idViewPOS interface viewDefault level2: System levelParametersbundle-id: Number of an HDLC link bundle. The value range for this argument is 1 to 240.DescriptionUse the bundle id command to assign a POS interface to an HDLC link bundle.Use the undo bundle id command to remove a POS interface from an HDLC link bundle.You cannot assign interfaces configured with the following features to an HDLC link bundle: IPv4addresses, IPv4 unnumbered, IPv6 addresses, and unicast reverse path forwarding (URPF). After aninterface is assigned to an HDLC link bundle, you cannot configure any of these features on the interface.You can assign only physical POS interfaces to HDLC link bundles.An interface can be the member of only one HDLC link bundle. To move an interface from one HDLC linkbundle to another HDLC link bundle, remove the interface from the current HDLC link bundle first.The link layer protocol of an interface to be assigned to an HDLC link bundle can only be HDLC. Youcannot change the link layer protocol of an HDLC link bundle member interface.You can assign physical POS interfaces to an HDLC link bundle before you create the bundle.Examples# Assign POS 5/1/1 to HDLC link bundle numbered 1. system-view[Sysname] interface Pos 5/1/1[Sysname-Pos5/1/1] bundle id 1bundle max-active linksSyntaxbundle max-active links numberundo bundle max-active linksViewHDLC link bundle interface view