47ppp mp short-sequenceSyntaxppp mp short-sequenceundo ppp mp short-sequenceViewInterface viewDefault level2: System levelParametersNoneDescriptionUse the ppp mp short-sequence command to trigger MP short sequence number header formatnegotiation. When the negotiation succeeds, the local end receives packets with short sequencenumbers.Use the undo ppp mp short-sequence command to restore the default.By default, the long sequence number header format is used.This command applies to the incoming direction only. To enable the local end to transmit packets withshort sequence numbers, configure the remote end to receive packets with short sequence numbers.NOTE:• The sequence number format (long or short) of an MP bundle depends on the configuration of the firstchannel joining the MP bundle.• To negotiate the use of short sequence numbers on a MP bundle, configure the command on everychannel in the MP bundle, because the command will cause PPP re-negotiation.Examples# Configure the short sequence number header format of MP on Serial 4/1/9/1:0. system-view[Sysname] interface Serial 4/1/9/1:0[Sysname-Serial4/1/9/1:0] ppp mp Mp-group 4/1/28[Sysname-Serial4/1/9/1:0] ppp mp short-sequencereset counters interface mp-groupSyntaxreset counters interface [ mp-group [ interface-number ] ]ViewUser viewDefault level2: System level
