H3C SR8800 Command Reference Manual

Also see for SR8800 IM-FW-II: Configuration guide Manual

Contents

H3C SR8800 Command Reference Manual Manual pdf 29 page image

21DescriptionUse the reset atm interface command to clear statistics about PVCs on ATM interfaces.This command does not clear the statistics about ATM interfaces. To clear the statistics about an ATMinterface, use the reset counters interface command. For more information about the reset countersinterface command, see Interface Command Reference.If you execute this command with an ATM main interface specified, this command clears the statistics onthe PVCs created on the ATM interface and its ATM subinterfaces. If you execute this command with anATM subinterface specified, this command clears the statistics about the PVCs created on the ATMsubinterface.If you execute this command with no ATM interface specified, the statistics about the PVCs created on allthe ATM interfaces are cleared.Examples# Clear the statistics about all the PVCs created on ATM subinterface ATM 3/1/1.1. reset atm interface Atm 3/1/1.1scrambleSyntaxscrambleundo scrambleViewATM main interface viewDefault level2: System levelParametersNoneDescriptionUse the scramble command to enable payload scrambling on the ATM interface. This, however, does notaffect cell headers.Use the undo scramble command to disable payload scrambling.By default, payload scrambling is enabled on an ATM interface.You can enable payload scrambling to prevent successive 0s or 1s in the payload.With payload scrambling enabled, the interface scrambles data before sending it and descramblesreceived data. With payload scrambling disabled, the interface neither scrambles sent data nordescrambles received data.NOTE:For normal communication, make sure that the same payload scrambling setting is configured on thecommunicating ATM interfaces.Examples# Enable payload scrambling on ATM interface 3/1/1.