H3C SR8800 Command Reference Manual

Also see for SR8800 IM-FW-II: Configuration guide Manual

Contents

H3C SR8800 Command Reference Manual Manual pdf 104 page image

96ParametersNoneDescriptionUse the modem auto-answer command to configure a modem to operate in auto-answer mode.Use the undo modem auto-answer command to configure a modem to operate in non-auto-answermode. Then, the modem answers a call only when it receives the AT command sent by the router.By default, a modem operates in non-auto answer mode.Use these two commands according to the actual answer mode of the modem. When the modem is inauto-answer mode (the AA LED of the modem lights up), use the modem auto-answer command toprevent the router from issuing answer instructions. If the modem is in non-auto answer mode, use theundo modem auto-answer command to enable the router to issue answer instructions on the arrival ofincoming calls.NOTE:• This command applies to only AUX ports.• If the answer mode configured is not consistent with the actual answer mode of the modem, the modemmay operate improperly. Do not perform the operation unless absolutely needed.Examples# Configure the modem connected to the asynchronous serial interface user-interface1 to operate inauto-answer mode. system-view[Sysname] user-interface aux 0[Sysname-ui-aux0] modem auto-answermodem timer answerSyntaxmodem timer answer timeundo modem timer answerViewUser interface viewDefault level2: System levelParameterstime: Timeout time (in seconds), ranging from 0 to 65535.DescriptionUse the modem timer answer command to set the maximum interval allowed between off-hook anddialing.Use the undo modem timer answer command to restore the default.By default, the interval is 60 seconds.

/ 107

Related manuals for H3C SR8800 IM-FW-II