H3C SR8800 Command Reference Manual

Also see for SR8800 IM-FW-II: Configuration guide Manual

Contents

H3C SR8800 Command Reference Manual Manual pdf 52 page image

44ViewMP-group interface viewDefault level2: System levelParametersNoneDescriptionUse the ppp mp fragment enable command to enable MP fragmentation.Use the undo ppp mp fragment enable command disable MP fragmentation.By default, MP fragmentation is enabled.If the peer device does not support fragment reassembly, you must configure the undo ppp mp fragmentenable command on the local router to disable MP fragmentation, thus enabling the two devices tocommunicate. After that, outgoing packets are not fragmented, but they still carry an MP sequencenumber and fragment tag.After you configure the undo ppp mp fragment enable command on an interface, the settings configuredwith the ppp mp min-fragment command become invalid on the interface.After configuring the ppp mp fragment enable command, you must use the shutdown and then undoshutdown commands to re-enable all the bundled physical interfaces for the new setting to take effect.Examples# Disable MP fragmentation on interface MP-group 4/1/28. system-view[Sysname] interface Mp-group 4/1/28[Sysname-Mp-group4/1/28] undo ppp mp fragment enableppp mp max-bindSyntaxppp mp max-bind max-bind-numundo ppp mp max-bindViewMP-group interface viewDefault level2: System levelParametersmax-bind-num: Maximum number of links allowed in an MP bundle, in the range of 1 to 128.DescriptionUse the ppp mp max-bind command to set the maximum number of links allowed in an MP bundle.Use the undo ppp mp max-bind command to restore the default.By default, the maximum number of links allowed in an MP bundle is 16. However, up to 12 links can bebrought up simultaneously in an MP bundle.