H3C SR8800 Command Reference Manual

Also see for SR8800 IM-FW-II: Configuration guide Manual

Contents

H3C SR8800 Command Reference Manual Manual pdf 62 page image

54DescriptionUse the bundle min-active links command to set the minimum number of selected interfaces required tobring up the HDLC link bundle.Use the undo bundle min-active links command to remove the limit.By default, no limit is set on the minimum number of selected member interfaces required to bring up anHDLC link bundle.The value specified by using this command cannot be bigger than that specified using the bundlemax-active links command.Related commands: bundle max-active links.Examples# Set the number of selected member interfaces required to bring up HDLC link bundle 1 to 5. system-view[Sysname] interface Hdlc-bundle 1[Sysname-Hdlc-bundle1] bundle min-active links 5defaultSyntaxdefaultViewHDLC bundle interface viewDefault level2: System levelParametersNoneDescriptionUse the default command to restore the default settings for an HDLC bundle interface.This command might fail to restore the default settings for some commands for reasons such as commanddependencies and system restrictions. You can use the display this command in interface view to checkfor these commands, and perform their undo forms or follow the command reference to individuallyrestore their default settings. If your restoration attempt still fails, follow the error message to resolve theproblem.CAUTION:The default command might interrupt ongoing network services. Make sure you are fully aware of theimpacts of this command when you perform it on a live network.Examples# Restore the default settings for HDLC link bundle interface 1. system-view[Sysname] interface Hdlc-bundle 1[Sysname-Hdlc-bundle1] defaultThis command will restore the default settings. Continue? [Y/N]:y