Other MessagesGARO Wxxxx (x represents a number) ........................................................................................................... 917ERROR Exxx-xxxx (x represents a letter or number) ...................................................................................... 917Hardware error. xxxxxxxx-xxxx (x represents a letter or number) ................................................................... 917Top cover is open. ........................................................................................................................................... 918Prepare for parts replacement. ........................................................................................................................ 918Parts replacement time has passed. ............................................................................................................... 918Unknown file. ................................................................................................................................................... 918Multi-sensor error ............................................................................................................................................ 919GARO Wxxxx (x represents a number)Cause Corrective ActionThere is a problem with the print job. Try printing again, using the correct printer driver.It is also possible to continue printing in this state.However, you may not be able to obtain the desired printing results.ERROR Exxx-xxxx (x represents a letter or number)Cause Corrective ActionAn error requiring service may have occurred. Write down the error code and message, turn off the printer, and con-tact your Canon dealer for assistance.Hardware error. xxxxxxxx-xxxx (x represents a letter or number)Cause Corrective ActionThe last portion of roll paper was used during a print job. Thepaper was not advanced because the trailing edge is taped tothe roll.Turn off the printer and remove the roll from the print-er before restoring power.Fastening tape or the Belt Stopper has not been removed in-side the Top Cover.Turn off the printer, open the Top Cover and removethe tape or the Belt Stopper before restoring power.An error requiring service may have occurred. Turn off the printer and wait at least three seconds be-fore restoring the power.If the message is displayed again, write down the errorcode and message, turn off the printer, and contactyour Canon dealer for assistance.Error Message > Other Messages >iPF815 GARO Wxxxx (x represents a number)13917
