Messages regarding printheadsCannot adjust printhead. ................................................................................................................................. 909Cannot adjust band. ........................................................................................................................................ 909PHead needs cleaning. ................................................................................................................................... 910Wrong printhead. ............................................................................................................................................. 910Problem with Printhead ................................................................................................................................... 910Printhead error ................................................................................................................................................ 910No printhead .................................................................................................................................................... 910Execute printhead cleaning. ............................................................................................................................ 911Cannot adjust printhead.Cause Corrective ActionThe Printhead noz-zles are clogged.Execute Auto Head Adj. again, as follows.1. Press the Online button to clear the error.2. Print a test pattern to check the nozzles.(See "Checking for Nozzle Clogging.") →P.8173. Clean the Printhead if the nozzles are clogged.(See "Cleaning the Printhead.") →P.8194. Execute Auto Head Adj. again.(See "Automatic Straightening of Lines and Colors (Auto Head Adj.).") →P.668The Printhead can-not be aligned; high-ly transparent film isloaded.Press the Online button to clear the error.We recommend using a type of paper that you often use, other than film, for Printhead adjust-ment.(See "Automatic Straightening of Lines and Colors (Auto Head Adj.).") →P.668The Printhead is in-stalled crooked.Straighten the Printhead as follows, and then execute Auto Head Adj. again.1. Press the Online button to clear the error.2. Use Head Inc. Adj. to adjust the angle of inclination of the Printhead.(See "Adjusting Line Misalignment (Head Inc. Adj.).") →P.6723. Execute Auto Head Adj. again.(See "Automatic Straightening of Lines and Colors (Auto Head Adj.).") →P.668Cannot adjust band.Cause Corrective ActionThe Printhead nozzles are clog-ged.Execute Auto Band Adj. again, as follows.1. Press the Online button to clear the error.2. Print a test pattern to check the nozzles.(See "Checking for Nozzle Clogging.") →P.8173. Clean the Printhead if the nozzles are clogged.(See "Cleaning the Printhead.") →P.8194. Execute Auto Band Adj. again.(See "Auto Band Adjustment (Auto Band Adj.).") →P.677Error Message > Messages regarding printheads >iPF815 Cannot adjust printhead.13909
