Cause Corrective ActionThe roll width set in Fit Roll Paper Width in theprinter driver does not match the width of the roll loa-ded in the printer.Hold down the Stop button for a second or more to cancelprinting.Make sure the roll width selected in the dialog box displayedwhen you select Fit Roll Paper Width in the printer drivermatches the width of the roll loaded in the printer, and thentry printing again.Paper size not detected.Cause Corrective ActionPaper has been loaded askew, or warped paper has been loaded. Follow these steps to reload the roll.1. Lift the Release Lever.2. Open the Top Cover.3. Adjust the right edge of the roll to make itparallel to the right Paper Alignment Line.4. Lower the Release Lever.5. Close the Top Cover.6. If "Not finished printing. Finish printingremaining jobs?" is shown on the DisplayScreen, press the OK button.Printing will resume, starting from the pageon which the error occurred.(See "Loading Rolls in the Printer.") →P.628If this error recurs after you reload the roll, re-move the Roll Holder from the printer, push theroll firmly in until it touches the Roll Holderflange, and reload the Roll Holder in the printer.(See "Attaching the Roll Holder to Rolls.")→P.623Follow these step to reload a sheet.1. Lift the Release Lever.2. Open the Top Cover.3. Adjust the right edge of the sheet to make itparallel to the right Paper Alignment Line andthe trailing edge of the sheet to make it paral-lel to the paper alignment line under the PaperRetainer.4. Lower the Release Lever.5. Close the Top Cover.6. If "Not finished printing. Finish printingremaining jobs?" is shown on the DisplayScreen, press the OK button.Printing will resume, starting from the pageon which the error occurred.Error Message > Messages regarding paper >iPF815 Paper size not detected.13895
