Cause Corrective ActionPrinting may be faint if Print Qual-ity in Advanced Settings in theprinter driver is set to Standard orDraft.(See "Giving Priority to Particular Graphic Elements and Colors for Print-ing.") →P.55Paper rubs against the printheadCause Corrective ActionThe type of paper specified in theprinter driver does not match thetype loaded in the printer.Load paper of the same type as you have specified in the printer driver.(See "Loading Rolls in the Printer.") →P.628(See "Loading Sheets in the Printer.") →P.651Make sure the same type of paper is specified in the printer driver as you haveloaded in the printer.1. Hold down the Stop button for a second or more to cancel printing.2. Change the type of paper in the printer driver and try printing again.Paper has been loaded incorrectly,causing it to wrinkle.Reload the paper.(See "Loading Rolls in the Printer.") →P.628(See "Loading Sheets in the Printer.") →P.651The Printhead is set too low. In Head Height, choose Automatic.(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.675You are printing on heavyweightpaper or paper that curls or wrin-kles easily after absorbing ink.When printing on Heavyweight Coated Paper or other paper-based media, choosea VacuumStrngth setting of Strong or Strongest. If paper still rubs against theprinthead, try raising the Printhead by setting Head Height to Highest.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.683(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.675When printing on CAD Tracing Paper or other film-based media, choose a Vac-uumStrngth setting of Standard, Strong, or Strongest. If paper still rubsagainst the printhead, try raising the Printhead by setting Head Height to High-est.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.683(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.675When printing on paper 0.1 mm (0.004 in) thin or thinner, choose a Vac-uumStrngth setting of Weakest. If paper still rubs against the printhead, try rais-ing the Printhead by setting Head Height to Highest.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.683(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).")→P.675When you have loaded paper, thepaper you have loaded does notmatch the type selected on theDisplay Screen.Be sure to select the correct type of paper in the printer menu when loading paper.(See "Loading Rolls in the Printer.") →P.628(See "Loading Sheets in the Printer.") →P.651Troubleshooting > Problems with the printing quality >iPF815 Paper rubs against the printhead12867
