Cause Corrective ActionPaper has been loaded askew, or warped paper has been loaded. (See "Loading Sheets in the Printer.")→P.651Because the Platen is soiled with ink or other substances, the sizeof the clear film cannot be detected.Open the Top Cover and clean the entire Platen.(See "Cleaning Inside the Top Cover.")→P.837Insufficient paper for jobCause Corrective ActionThe printer has received a print job longer than the amount of roll paper left whenManageRemainRoll in the printer menu is On and one of the following settingsis selected.• During HP-GL/2 printing, GL2 Settings >Paper Source in the printer menu isset to an option other than Automatic.• The Media Take-up Unit is in use.Press the Online button to resumeprinting.However, the roll paper may runout during the print job and youmay not be able to print all of thedocument.Hold down the Stop button for asecond or more to cancel printing.Either change the printer driverPaper Source setting or the GL2Settings >Paper Source settingin the printer menu or replace theroll with a roll that has enough pa-per for the print job, and then tryprinting again.If you are using the Media Take-up Unit, remove the printed docu-ment from the Media Take-upUnit before replacing the roll witha roll that has enough paper forthe print job, and then try printingagain.(See "Removing the Roll fromthe Printer.") →P.634(See "Loading Rolls in the Print-er.") →P.628(See "Removing Printed Docu-ments from the Media Take-upUnit.") →P.761Error Message > Messages regarding paper >Insufficient paper for job iPF81513896
