15. Click E Fit Paper Size under D Enlarged/Reduced Printing.16. In I Paper Size, click the paper size. In this case, click 10"x12" - Borderless.17. Confirm the print settings, and then click M Print to start printing.Note• For tips on confirming print settings, see "Confirming Print Settings (Mac OS X) →P.429 "Borderless Printing by Resizing Originals to Fit the Roll WidthTake advantage of borderless printing to print documents such as posters (made up mainly of photos or images) without asurrounding margin, or border.Borderless PrintingIn regular printing, a margin required by the printer is added around the original. With borderless printing, you can printdocuments without the margin, so that the printed image covers the entire surface of the paper.Important• Borderless printing is only available with rolls.• Paper you can use for borderless printing is restricted to particular types of paper and rolls of particularwidths. For information on types of paper compatible with borderless printing, refer to the Paper ReferenceGuide. (See "Types of Paper →P.617 ")• Paper incompatible with the printer's auto cut function can be printed without borders on the left and rightsides only.• These features cannot be used in combination with borderless printing: special page layouts, centering origi-nals, and printing cut lines on rolls.• If Fit Paper Size or Print Image with Actual Size (Windows only) is selected when performing borderlessprinting, Rotate Page 90 degrees (Conserve Paper) cannot be selected.• When borderless printing is used, the edge of the paper is cut during printing. Thus, ink density may be un-even at the edges. If you require higher image quality, specify No in Auto Cut in the printer driver. In thiscase, the paper can be printed without borders on the left and right sides only. After ejecting and cutting theprinted document, use scissors to cut away the top and bottom edges.• By factory default, the ink drying time is disabled for all paper. When you are using paper that takes longerfor ink to adhere for borderless printing and the Cutter Unit touches printing surfaces that are not dry yet, itmay damage the paper or the edge of the document that is cut, depending on frequency of use. In this case,follow these steps to change the ink drying time.1. On the Main sheet of the printer driver, click Settings in Media Type.2. Select the ink drying time in the Between Pages list of Drying Time.• Before borderless printing, make sure the blue Switch on the platen is set toward the ● side. (See "Settingthe Blue Switch on the Platen.") →P.872Borderless Printing MethodChoose the method of borderless printing that suits the original, as desired.Enhanced Printing Options > Borderless Printing >iPF815 Borderless Printing by Resizing Originals to Fit the Roll Width3107
