Cause Corrective ActionThe Cutter Unit stops inthe middle of cutting.(See "Specifying the Cutting Method for Rolls.") →P.642In other cases, the CutterUnit may be damaged.Contact your Canon dealer for assistance.End of paper feed.Cause Corrective ActionYou are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge. Release the ▲ button.Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit. Release the ▲ button.Rel lever is in wrong position.Cause Corrective ActionThe Release Lever is up. Lower the Release Lever.If the error occurs again, turn off the printer and wait a while before restoring power.Rewinding error.Cause Corrective ActionThere is some foreign object near the Media Take-up Unit sensorand the roll cannot be detected.Remove the foreign object near the sensor.The Media Take-up Unit sensor is soiled and the roll cannot be de-tected.Wipe the sensor with a dry cloth to clean it.The roll is out of range of detection by the Media Take-up Unit sen-sor.Reload the roll.(See "Loading Rolls in the Printer.") →P.628The Media Take-up Unit sensor is damaged. Contact your Canon dealer for assistance.A paper jam has occurred and the roll cannot be rewound. Remove the paper from the Media Take-up Unit.Press the Online button to clear the error.*Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not tostop, set Skip Take-Up Err to On.Media take-up unit ready.Cause Corrective ActionThe Take-up Reel setting in the printer MAIN MENUwas changed from Enable to Disable, but a print job wasreceived before the roll was removed.Press the Stop button and stop printing.The mode switches from take-up mode to regular mode af-ter you change the Take-up Reel setting in the MAINMENU from Enable to Disable and lift the Release Lever,or after you execute Paper Cutting.Error Message > Messages regarding paper >End of paper feed. iPF81513902
