Item Details Default SettingZone (*2) However, do not use the following single-byte characters: @, :, and =. Also avoid us-ing * (which represents the default zone) in the middle of a string.**1:The object name you have specified in Name is displayed in Printer Setup Utility (or Print Center ) in Mac OSX 10.2.8–10.4. If you use multiple printers in the same zone, assign a unique name to each printer. By default,the network interface name is Canon NB-17FB (xxxxxx). (Here, xxxxxx is the last six digits of the printer'sMAC address.)*2: If zones have been created on the network, enter the name of the printer's zone. If there are no zones, leave theasterisk * entry (for the default zone) as it is. If you enter a network zone name that does not match createdzones, the printer will not be detected by Macintosh computers. Consult your network administrator for informa-tion on zone names.7. Click OK to display the Network page.Configuring the Destination for AppleTalk NetworksTo print over an AppleTalk network, activate the AppleTalk protocol and configure the destination as follows.Activating AppleTalk on the printerImportant• By factory default, the AppleTalk protocol is disabled on the printer.1. Press the Menu button to display MAIN MENU.2. Press ▲ or ▼ to select Interface Setup, and then press the ▶ button.3. Press ▲ or ▼ to select AppleTalk, and then press the ▶ button.4. Press ▲ or ▼ to select On, and then press the OK button.Network Setting > Network Setting (Mac OS X) >Configuring the Destination for AppleTalk Networks iPF81510794
