HP-GL/2 problemsLines or images are missing in the HP-GL/2 data that was printed. ............................................................... 882Lines Are Printed Too Thick or Thin During HP-GL/2 Printing ........................................................................ 882HP-GL/2 jobs are printed in monochrome (or color). ...................................................................................... 882Printed Colors in Line Drawings are Inaccurate During HP-GL/2 Printing ...................................................... 882HP-GL/2 jobs are printed 6 mm larger than specified ..................................................................................... 883HP-GL/2 jobs are printed at maximum size, even if a standard size is specified ............................................ 883HP-GL/2 printing takes a long time. ................................................................................................................ 883The printer stops when printing a HP-GL/2 job (the carriage stops moving) ................................................... 883Lines or images are missing in the HP-GL/2 data that was printed.Cause Corrective ActionThe memory is full. Check the size of the data in the print job.An HP-GL/2 command not supported by this printer was re-ceived.Check the print job and settings.The printer has received print data that includes HP RTLcommands when Auto Rotate is On.Set Auto Rotate to Off before attempting to print again.(See "Main Menu Settings.") →P.722Lines Are Printed Too Thick or Thin During HP-GL/2 PrintingCause Corrective ActionThe Line Width setting inthe main menu is incorrect.Confirm the selection in Line Width. If fine lines are printed faint, setting ThickenFi-neLines to On in the main menu will print the lines more distinctly.(See "Main Menu Settings.") →P.722HP-GL/2 jobs are printed in monochrome (or color).Cause Corrective ActionThe Color Mode isincorrect.On the printer Control Panel, check the Color Mode setting.(See "Main Menu Settings.") →P.722However, for optimal Printhead performance, the printer consumes trace amounts of color inkeven when Monochrome is selected as Color Mode.Printed Colors in Line Drawings are Inaccurate During HP-GL/2 PrintingCause Corrective ActionAdjustFaintLines in the main menuis set to On.Selecting Off may help produce the expected results. However, lines in somecolors may appear broken.Troubleshooting > HP-GL/2 problems >Lines or images are missing in the HP-GL/2 data that was printed. iPF81512882
