Cannot print over a networkCannot connect the printer to the network ...................................................................................................... 878Cannot print over a TCP/IP network ................................................................................................................ 878Cannot print over a NetWare network ............................................................................................................. 879Cannot print over AppleTalk or Bonjour networks ........................................................................................... 879Cannot connect the printer to the networkCause Corrective ActionThe Ethernet cableis not connectedcorrectly to theprinter's Ethernetport.1. Make sure the printer is connected to the network with the correct Ethernet cable, and thenturn the printer on. For instructions on connecting the cable, refer to the Setup Guide.2. Make sure the Link indicator is lit.The Link indicator is green if the printer is connected via 100 Base-TX and orange if connec-ted via 10Base-T.If the Link indicator is not lit, check the following points.• Make sure the hub is on.• Make sure the end of the Ethernet cable is connected correctly.Insert the Ethernet cable until it clicks and locks in place.• Make sure there is no problem with the Ethernet cable.If there is any problem, replace the Ethernet cable.• Check the communication mode with the hub.Although the printer normally detects the hub communication mode and transmission rateautomatically (in auto negotiation mode), sometimes the hub settings cannot be detected.In this case, configure the connection method manually, specifying the communicationmode in use.(See "Configuring the Communication Mode Manually.") →P.780Cannot print over a TCP/IP networkCause Corrective ActionThe printer's IP address is notconfigured correctly.Make sure the printer's IP address is configured correctly.(See "Configuring the IP Address Using imagePROGRAF Device Setup Utili-ty.") →P.404(See "Configuring the IP Address Using the Printer Control Panel.") →P.774The printer's TCP/IP network set-tings are not configured correctly.Make sure the printer's TCP/IP network settings are configured correctly.(See "Configuring the Printer's TCP/IP Network Settings.") →P.777The computer you are trying toprint from is not configured cor-rectly.Make sure the computer's TCP/IP network settings are configured correctly.(See "Configuring the Printer Driver Destination .") →P.783(See "Configuring the Destination for TCP/IP Network .") →P.797Troubleshooting > Cannot print over a network >Cannot connect the printer to the network iPF81512878
