Using the Media Take-up UnitThis topic describes how to use the Media Take-up Unit.Important• The Media Take-up Unit cannot be used with sheets.• Do not put anything near the Media Take-up Sensor that might interfere with it. This may impair operation.• Rolls are not cut automatically when the Media Take-up Unit is used, regardless of the Cutting Mode settingin the printer menu or the Automatic Cutting setting in the printer driver.• Color tones after printing may change during the ink drying period for some types of paper. Allow ampledrying time before the final check of colors, and do not remove printed documents from the Media Take-upUnit too soon.• In humid environments, documents printed on relatively insubstantial media such as Fabric Banner, Synthet-ic Paper, or lightweight Coated Paper may not be retracted evenly by the unit. In this case, take steps to con-trol humidity in the operating environment, or adjust the Roll DryingTime or Scan Wait Time settings sothat printed documents are retracted after the ink has fully dried. (See "Main Menu Settings.") →P.7221. When using the Stationary Output Stacker, stow the Stationary Output Stacker before this procedure. (See "Stowingthe Stationary Output Stacker.") →P.661Important• Arrange the Basket Cloth and Basket Rod so they do not interfere with the Media Take-up Sensor.2. Unlock the flange on the left side of the Rewind Spool by lifting the lever (a) from the shaft side. Remove theflange.Printer Parts > Optional accessories >Using the Media Take-up Unit iPF8159754
