2. In Windows, open a command prompt, or in Mac OS X, start Terminal.3. Execute the following command to add entries to the ARP table for managing IP addresses and corresponding MACaddresses.arp -s [IP address] [the printer's MAC address you have verified]Example: arp -s xxx.xxx.xxx.xxx 00-00-85-xx-xx-xxNote• In Mac OS X when using Terminal, enter the arp command in the format arp -s xxx.xxx.xxx.xxx00:00:85:xx:xx:xx. For details, refer to the help file for the command line.4. Execute the following command to send the IP address to the printer and configure it.ping [IP address as specified in the ARP command] -l 479Example: ping xxx.xxx.xxx.xxx -l 479Note• In -l, the l is the letter l.• In Mac OS X when using Terminal, enter the ping command in the format ping -s 479xxx.xxx.xxx.xxx. For details, refer to the help file for the command line.Note• The subnet mask and default gateway will be set to 0.0.0.0. Use RemoteUI to change the subnet mask anddefault gateway to match your network settings.For details on RemoteUI, see "Using RemoteUI." →P.776Using RemoteUIEnter the printer's IP address in a web browser to display the RemoteUI page. After you log on to RemoteUI from the page,you can check and change the status of the printer and print jobs, and configure network settings.To access RemoteUI, start the web browser and enter the following URL in the Location (or Address ) box to display theRemoteUI page.http://printer IP address or name/Example: http://xxx.xxx.xxx.xxx/For details on configuring printer settings for networks, refer to the following topics.• Configuring the Printer's TCP/IP Network Settings →P.777• Configuring the Printer's AppleTalk Network Settings →P.793• Configuring the Printer's NetWare Network Settings →P.784• Specifying Printer-Related Information →P.778Note• RemoteUI also offers many other features. You can display the ink levels, check error messages and otherstatus information, and cancel print jobs.• By factory default, the English screen is displayed. To change the display language, select the desired lan-guage under Language before logging on in administrator mode.Network Setting > Network Setting >Using RemoteUI iPF81510776
