Panasonic WJ-HD500B Operating Instructions Manual

Contents

Panasonic WJ-HD500B Operating Instructions Manual Manual pdf 8 page image

8Designation Rear View16161515141413131212111110109988776655443 22311SIGNAL GND10/100 BASE-TSPOTOUTIN EXT STORAGE COPYCONTROL ALARMVIDEOMODEDATA REMOTE(WV-CU50)GEN-LOCK OUTSERIALPOWERONACINOFFINOUTOUTMULTI SCREEN OUT AUDIO$1^0$2%9$3 $4 $5 $6 $7 $8 $9 %0 %1 %2%3 %4 %5 %6%7%8$1 Multiscreen Output Connector (MULTISCREEN OUT)The video output signal for the Multiscreen Monitor isprovided via this connector.It can be displayed as the video input in a multiscreenmode (4, 7, 9, 10, 13,16 screen segments).It also displays the Recorder’s playback images.Pressing the SETUP/ESC button for two seconds ormore will automatically select the Multiscreen Monitorand display the Disk Recorder’s Setup menu.$22 Spot Output Connector (SPOT OUT)The video output signal for the Spot Monitor is providedvia this connector.Displaying the Disk Recorder’s playback is disabled.$3 Audio Input Connector (AUDIO IN)For audio input from an external device, if applicable.$4 Audio Output Connector (AUDIO OUT)For audio output to an external device, if applicable.$5 Extension Storage Port (EXT STORAGE)For connecting the optional Extension Unit.$6 Control Port (CONTROL)The port has the functions listed below. Make connec-tions to these pins as needed for operating your sys-tem.PinNo.12345678910111213Group Recording OutputManual Recording OutputEmergency RecordingOutputSequence Timing OutputDVD Remain SpaceOutputHDD Remain SpaceOutputThermal Error Input(Extension 1)Thermal Error Input(Extension 2)Thermal Error Input(Extension 3)Thermal Error Input(Extension 4)Thermal Error Input(Extension 5)Thermal Error Input(Extension 6)Thermal Error Input (DVDUnit)PinNo.141516171819202122232425DesignationDisk Recorder ErrorOutputGroundGroundPower Failure Detect InputPower Failure ProceedingOutputPower Failure ProcessCompletion OutputGroundEmergency RecordingInputTime Adjustment OutputDaylight Savings SelectTime Adjustment InputGroundCONTROL1131425@9 Direction Buttons (CDA B)These buttons are used to select an area for a zoomedimage displayed on the Multiscreen Monitor.During the setup, these buttons are used to move thecursor position in the setup menu of the Disk Recorder.C: DownwardD: UpwardA: LeftB: Right#0 Full Indicator (FULL)Lights to indicate when the available recording spaceof the Disk Recorder (HDD) is running low.#1 Hard Disk Drive Indicator (HDD)Lights to indicate when the Hard Disk is activated.The pin assignment of the port is shown below.