742. Select an item or item parameter in the menu by press-ing the D or C button.3. To return to the previous setup menu, press theSETUP/ESC button. Disk Information1. Move the cursor to DISK INFORMATION in the DISKMANAGEMENT menu by pressing the C or D button,then press the SET button.The DISK INFORMATION table appears on the monitor,as shown below.2. To return to the previous setup menu, press theSETUP/ESC button. Disk Space IndicatorThis item lets you determine the indication mode for theFULL indicator when the remaining storage capacity is run-ning low on the Hard Disk.1. Move the cursor to the HDD FULL parameter in theDISK MANAGEMENT menu by pressing the C or Dbutton.2. Select the desired indicator mode by pressing the + or- button.OFF: No warning for remaining space1 - 10%: The selected warning is issued if the remain-ing storage capacity is between 1 and 10%.The factory default setting is 1%.Note: This setting is applied to the display on the moni-tor screen and signal output from the CONTROLport.4. Select either YES or NO by pressing the + or - but-ton.Select YES, then press the SET button to execute theselection (save or load).The display shown below appears on the monitor5. To return to the previous setup menu, press theSETUP/ESC button. Disk ManagementThe Hard Disk status can be displayed on the monitorscreen.1. Move the cursor to DISK MANAGEMENT in the SYSTEMSETUP menu by pressing the C or D button, thenpress the SET button.The DISK MANAGEMENT menu shown below appearson the monitor.9-3-1 DISK INFO HDD TOTAL:¢¢¢GBHOURS HOURS HOURS HOURSMAIN 1:30000 2:30000EXT5 1:30000 2:30000 3:30000 4:30000EXT4 1:* 2:* 3:* 4:*EXT3 1:- 2:- 3:- 4:-EXT2 1:- 2:- 3:- 4:-EXT1 1:- 2:- 3:- 4:-EXT0 1:- 2:- 3:- 4:-EXT DVD:OKFORMAT:HD500 LEFT10% ¢¢GBDATE :SEP12.00 12:25 SEP12.00 16:25STATUS:OK9-1 USER DEFINED SETUPLOAD USER DEFINED SETUPLOADING COMPLETE!9-2 USER DEFINED SETUPSAVE USER DEFINED SETUPSAVING COMPLETE!9-3 DISK MANAGEMENTDISK INFORMATIONHDD FULL 1%ERASE