Panasonic WJ-HD500B Operating Instructions Manual

Contents

Panasonic WJ-HD500B Operating Instructions Manual Manual pdf 6 page image

6MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS Front ViewREMOTETIMEROPERATEFULLHDD SEQUENCESETLOCKALARMALARMRESETALARMSUSPENDMULTISCREENSELECTSETUP/ESCGROUPSELECTSPOTMULTISCREENDAYLIGHT SAVINGSEL-ZOOMCOPYREC PREVIEW INDEXSTOP BPLAY/ PAUSE RECFWDREVALARM SEARCHDISPLAYREC STOP1 2 3 413 14 15 169 10 11 125 6 7 8Digital DiskRecorderWJ-HDFS 16qwe t y u !0 !1r i o!3 !4 !5 !6 !7 !8 !9 @0!2@1@3@4@5@6 @2@7@8@9#0#1Bq Operate Indicator (OPERATE)Is on when the power of the WJ-HD500B Digital DiskRecorder is turned on.w Timer Indicator (TIMER)Lights to indicate when the TIMER is set to INT (internaltimer) in the setup menu.e Remote Indicator (REMOTE)Lights to indicate when the Disk Recorder is controlledby an outboard device via the Serial or 10/100BASE-Tport on the rear of the Disk Recorder.r Alarm Suspend Indicator (ALARM SUSPEND)Lights to indicate that the alarm suspension mode isselected.t Alarm Reset Button (ALARM RESET)This button cancels an activated alarm.Pressing this button will reset the alarm and return thesystem to the condition before the alarm function wasactivated.y Alarm Indicator (ALARM)This indicator blinks to indicate that an alarm conditionexists.It changes to a steady light when the alarm is resetautomatically.To turn the indicator off, press the ALARM RESET but-ton.u Sequence Button (SEQUENCE)Runs the assigned sequence on the selected monitorscreen for the specified duration.During the sequence, pressing this button will pausethe sequence that is being run on the monitor screen.The LED indicates the status as follows.On: Sequence is being run.Blinking: Sequence is in pause mode.i Multiscreen Selection Button(MULTISCREEN SELECT)Selects the multiscreen pattern to be displayed on theMultiscreen Monitor that is connected to the MULTISCREEN OUT on the rear of the Recorder.Pressing this button will toggle the display on the moni-tor screen as shown below.4 → 7 → 9 → 10 → 13 → 16 → 4 screen segmentso Monitor Selection Button (SPOT/MULTISCREEN)Selects to control the display on the screen for eitherthe Spot or Multiscreen Monitor.Pressing this button will toggle the indicator in the but-ton on and off to indicate the selected monitor as shownbelow.On: Indicates the Spot monitor is selected.Off: Indicates the Multiscreen monitor is selected.!0 Lock Button (LOCK)Toggles to enable or disable the button lock function onboth front panels of the Disk Recorder and RemoteController.The LED indicates the status as shown below.On: The button lock is enabled.Off: The button lock is disabled.While On, the button lock will be released only if thepreset password is entered in the password inquiry win-dow.