Panasonic WJ-HD500B Operating Instructions Manual

Contents

Panasonic WJ-HD500B Operating Instructions Manual Manual pdf 60 page image

606. Repeat the above steps 2 to 5 to set up the other steps.7. When satisfied with all of the above steps, press theSETUP/ESC button to return to the previousSEQUENCE SETUP menu. Sequence Timing SettingThis item lets you select between internal and external con-trol for advancing the sequence on the Spot Monitor.1. Move the cursor to the SEQ TIMING parameter in theSEQUENCE SETUP menu by pressing the D or C but-ton.2. Select either INT or EXT by pressing the + or - but-ton.INT: Advances a sequence by the Dwell Time that wasprogrammed on the SPOT LIVE SEQUENCESETUP.EXT: Advances a sequence by the input from pin 5 ofthe ALARM port.The factory default setting is INT. Auto Skip SettingThis item lets you enable or disable the auto skip functionon the Spot Monitor to skip any steps when no video signalis present.1. Move the cursor to the AUTO SKIP parameter in theSEQUENCE SETUP by pressing the D or C button.2. Select either ON or OFF by pressing the + or - but-ton.ON: Enables the auto skip function on the Spot Monitor.OFF: Disables the auto skip function on the SpotMonitor.The factory default setting is ON.Power on Status SetupThe items let you select a pattern on the monitor screenwhen the Disk Recorder’s power is turned on. Power on Setting (MultiscreenMonitor)This item lets you select a display pattern on theMultiscreen Monitor when the Disk Recorder’s power isturned on.1. Move the cursor to the MULTI OUTPUT parameter inthe MULTIPLEXER SETUP menu by pressing the D orC button.2. Select a display pattern to be set by pressing the + or- button.1 - 16: Selects an assigned camera image in singlespot mode.SPOT SEQ: Selects a sequence pattern programmedin the Live Sequence (Spot Monitor).QUAD-4A to QUAD-4D: Selects an assigned quad dis-play in spot mode.QUAD SEQ: Selects a sequence pattern programmedin the Live Sequence (Multiscreen Monitor).7 to 16SCREEN: Selects a display with the assignedsegment.The factory default setting is QUAD-4A. Power on Setting (Spot Monitor)This item lets you select a display pattern on the SpotMonitor when the Disk Recorder’s power is turned on.1. Move the cursor to the SPOT OUTPUT parameter in theMULTIPLEXER SETUP menu by pressing the D or Cbutton.2. Select a display pattern to be set by pressing the + or- button.1 - 16: Selects an assigned camera image in singlespot mode.SPOT SEQ: Selects a sequence pattern programmedin the Live Sequence (Spot Monitor).The factory default setting is 1.