10 WV-CU50 Remote Controller&1 Lock Button (LOCK)Toggles to enable or disable the button lock function onboth front panels of the Disk Recorder and RemoteController.The LED indicates the status as shown below.On: The button lock is enabled.Off: The button lock is disabled.While On, the button lock will be released only if thepreset password is entered in the password inquiry win-dow.&2 Monitor Selection Button(SPOT/MULTISCREEN)Selects either the Spot or Multiscreen Monitor for whichyou wish to control the display on the screen.The LED indicates the status as shown below.On: The Spot Monitor is selected.Off: The Multiscreen Monitor is selected.&3 Multiscreen Selection Button(MULTISCREEN SELECT)Selects the multiscreen pattern to be displayed on theMultiscreen Monitor.Pressing this button will change the screen pattern asfollows.4 → 7 → 9 → 10 → 13 → 16 → 4 screen segments&4 Recording Preview Button (REC PREVIEW)Use this button to display the playback image with thelive images on the Multiscreen Monitor.The LED indicates the status as shown below.On: The selected playback image is displayedBlinking: Prompts you to select the numeric button fordisplaying the playback image.&5 Sequence Button (SEQUENCE)Runs the assigned sequence on the selected monitorscreen for the specified duration.During the sequence, pressing this button will pausethe sequence that is being run on the monitor screen.The LED indicates the status as shown below.On: Sequence is being run.Blinking: Sequence is in pause mode.REMOTE1615141312111095 6 7 84321PAUSERemote Controller WV-CU50FWDREVLINKSETRECPLAY/STOPSTOPRECDISPLAYALARMSEARCHINDEXGROUPEL-ZOOMSEQUENCEPREVIEWRECMULTISCREENSELECTSPOTMULTISCREEN COPYLOCKSELECTALARMRESET*1&1&2&3&4&5&6(2&8&7&9*0*2 *3*6*5*4*7*8*9(0(1(3
