3 - DIRECT-TO64ShortcutsShortcuts are available when using the direct-tokey, allowing you to bypass the use of the small andlarge right knobs to enter the destination waypoint’sidentifier. A direct-to can be performed from any pagedisplaying a single waypoint identifier (such as theWPT pages for airports and navaids) by simply press-ing direct-to and ENT. For pages that display a listof waypoints (e.g., the nearest airport page), you musthighlight the desired waypoint with the cursor beforepressing the direct-to key.To select an on-screen waypoint (other than themap page) as a direct-to destination:1. If a single airport, navaid or user waypoint isdisplayed on-screen: press direct-to, thenpress ENT twice.2. If a list of waypoints is displayed on-screen:press the small right knob to activate thecursor, turn the large right knob to highlightthe desired waypoint, then press direct-tofollowed by ENT twice.Direct-to destinations may also be selected fromthe map page, by panning to the desired destinationlocation and pressing direct-to and ENT (twice).If no airport, navaid or user waypoint exists at thedesired location, a waypoint named “+MAP” willautomatically be created at the location of the pan-ning pointer.To select a direct-to destination from the mappage:1. From the map page, press the small rightknob to display a panning pointer.2. Turn the small and large right knobs to placethe panning pointer at the desired destinationlocation.3. If the panning pointer is placed on an existingairport, navaid or user waypoint, the waypointname will be highlighted. Press direct-to andthen ENT twice to navigate to the waypoint.4. If the panning pointer is placed on an openlocation, press direct-to and ENT twice tocreate a “MAP” waypoint and navigate to it.Direct-to Shortcuts
