9 - AUX PAGES169Setup 1To change the units of measure:1. Select “Units / Mag Var” from the Setup 1page.2. Turn the large right knob to highlight thedesired units of measure category. The fol-lowing categories, and corresponding units ofmeasure, are available:• DIS, SPD—distance and speed in Nautical(nautical miles/knots), Statute (miles/milesper hour) or Metric (kilometers/kilometers perhour) terms.• ALT, VS—altitude and vertical speed in Feet/feet per minute, Meters/meters per minute, orMeters/meters per second.• PRESSURE—barometric setting in Inches orMillibars.• TEMP—temperature in degrees Celsius orFahrenheit.• FUEL—fuel units in Gallons, Imperial Gal-lons, Kilograms, Liters or Pounds.3. Turn the small right knob to select the desiredunits of measure for the selected category.Press ENT to accept the selection.Position FormatTo change the position format:1. Select “Position Format / Map Datum” fromthe Setup 1 page.2. The flashing cursor is on the position formatfield. Turn the small right knob to select thedesired position format. The following positionformats are available:• hddd°mm.mmm’—latitude and longitude indegrees and decimal minutes• hddd°mm’ss.s”—latitude and longitude indegrees, minutes and decimal seconds• MGRS—Military Grid Reference System• UTM/UPS—Universal Transverse Mercator /Universal Polar Stereographic grids3. Press ENT to accept the selected format.