Garmin GPS 400W,GNC 420W Pilot's Manual & Reference

Also see for 400W Series: Supplemental Flight manual Pilot's guide addendum Manual supplement Pilot's guide addendum Quick reference guide

Contents

Garmin GPS 400W,GNC 420W Pilot's Manual & Reference Manual pdf 178 page image

9 - AUX PAGES168To change the ILS CDI selection:1. Select “CDI / Alarms” from the setup 1 page.2. Turn the large right knob to highlight the“Auto”/”Manual” ILS CDI field.3. Turn the small right knob to select “Auto” or“Manual”, as desired. Press ENT to accept theselection.NOTE: Installations with certain autopilots, suchas the KAP 140 and KFC225) do not allow auto-matic ILS CDI switching.To set the arrival alarm and alarm distance:1. Select “CDI / Alarms” from the setup 1 page.2. Turn the large right knob to highlight the“On”/”Off” field (directly below “ArrivalAlarm”).3. Turn the small right knob to select “On” or“Off”, as desired. Press ENT to accept theselection.4. The flashing cursor moves to the alarm dis-tance field (to the immediate right of “On” or“Off”). To enter an arrival alarm distance, usethe small and large right knobs to enterthe desired alarm distance. Press ENT whenfinished.Units / Mag VarTo set the magnetic variation:1. Select “Units / Mag Var” from the Setup 1page.2. The flashing cursor highlights the headingmode field. Turn the small right knob to selectthe desired heading mode: Auto or True. PressENT to accept the selection.Setup 1