6TAKEOFF TOURInstrument Panel Self-TestInstrument Panel Self-TestOnce the database has been acknowledged, theinstrument panel self-test page will appear. To ensurethat your 400W-series unit and any connected instru-ments are working properly, check for the followingindications on your CDI/HSI, RMI, external annuncia-tors and other connected instruments:• Course deviation• Glideslope• TO/FROM flag• Time to destination• Bearing to destination• Desired track• Distance to dest.• Ground speed• All external annunciators (if installed)The instrument panel self-test page indicates the cur-rently selected OBS course, fuel capacity (CAP), fuelon board (FOB) and fuel flow (FF). The fuel capacity,fuel on board and fuel flow may be manually enteredif your installation does not include connection to sen-sors which automatically provide these figures.To enter fuel capacity, fuel on board or fuel flowfigures (if not provided by sensors):1. Turn the large right knob to select the “CAP”,“FOB” or “FF” field.2. Turn the small and large right knobs to enterthe desired figure, then press ENT.Enter the fuel capacity, fuel on board or fuelflow figures directly onto the appropriatefield of the instrument panel self-test page.These figures will automatically be providedif your installation includes connection toexternal sensors.Fuel Figures: May beentered manually if nosensor presentSelect to displayChecklists PageCheck CDI/HSI,RMI and otherinstrumentsto verify theseindicationsShould match currentOBS course selectionSelect to Set Fuel Levelto Full Capacity{ }
