Manag-eRemain-RollBarcodes Printer Operation After the Paper is FedOn Not prin-tedA menu for selection of the paper type and length is automatically shown on the DisplayScreen.Press ▲ or ▼ to select the type and length of paper loaded, and then press the OK button.Note• For details on types of paper to select, see the Paper Reference Guide. (See "Types of Paper.")→P.5628. Holding it at the positions indicated, close the Roll Cover.Note• Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissors orthe blade after removing creased edges. (See "Specifying the Cutting Method for Rolls.") →P.586Changing the Type of PaperFollow these steps to change the type of paper specified on the printer after you have loaded paper.If you will continue using this type of paper later, selecting Keep Paper Type > On will save the time and effort of config-uring the media type setting when you load the paper again. The current media type settings before you select On will beautomatically selected at that time. (See "Using the Same Type of Paper Regularly.") →P.576Important• For best printing results, the printer fine-tunes the feed amount for each type of paper. Be sure to select thetype of paper to use correctly before printing.• Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printedimages may vary depending on the type of paper used. If margins and the size of images are not as you ex-pected, adjust the paper feed amount.(See "Adjusting the Feed Amount.") →P.615Changing the Type of PaperNote• After you load a roll, the printer automatically shows a menu for selection of the type of paper on the DisplayScreen. Select the type of paper and press the OK button.If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the rolllength after the type of paper. (See "Specifying the Paper Length.") →P.577Handling Paper > Handling rolls >iPF650 Changing the Type of Paper6575
