For details on configuring printer settings for networks, refer to the following topics.• Configuring the Printer's TCP/IP Network Settings →P.693• Configuring the Printer's AppleTalk Network Settings →P.711• Configuring the Printer's NetWare Network Settings →P.701• Specifying Printer-Related Information →P.696Note• RemoteUI also offers many other features. You can display the ink levels, check error messages and otherstatus information, and cancel print jobs.• By factory default, the English screen is displayed. To change the display language, select the desired lan-guage under Language before logging on in administrator mode.• If you login in Administrator Mode, you can configure to use the Jumbo Frame function in the Networkpage. However, this function might not be able to be used depending on the network environment.Important• Use Netscape Navigator 6.0 or later, Internet Explorer 5.01 or later, or Firefox 1.5 or later as a web browser.In Mac OS X, you can also use Safari 1.32 or later or Safari 2.03 or later.• Access is not possible via a proxy server. In environments where a proxy server is used, add the printer's IPaddress to Exceptions (addresses accessed without a proxy server) in the web browser proxy server settings.(Settings may vary depending on the network environment.)• Enable JavaScript and cookies in the web browser.• If you access RemoteUI with the printer name instead of its IP address, make sure the DNS settings are cor-rectly configured.• RemoteUI might not be able to start depending on the network environment.• Check that Use RemoteUI in System Setup is set to On in the printer Control Panel.Configuring the Printer's TCP/IP Network SettingsFollow the steps below to configure the TCP/IP network settings.When using an IPv4 IP address1. Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUIpage.http://printer IP address or name/Example: http://xxx.xxx.xxx.xxx/2. Select Administrator Mode and click Logon.3. If a password has been set on the printer, enter the password.4. Click Network in the Device Manager menu at left to display the Network page.5. Click Edit in the upper-right corner of the TCP/IPv4 group to display the Edit TCP/IP Protocol Settings page.Network Setting > Network Setting >iPF650 Configuring the Printer's TCP/IP Network Settings9693
