Roll paper cannot be inserted into the paper feed slotCause Corrective ActionThe roll paper is warped. Straighten out curls and reload the roll.Paper is jammed by the paper feed slot. Remove the jammed paper.(See "Clearing Jammed Roll Paper.") →P.759(See "Clearing a Jammed Sheet.") →P.763The paper source selection is incorrect. Press the Load button and select the paper source.Cannot load sheetsCause Corrective ActionThe paper source selection is incorrect. Press the Load button and select the paper source.Paper is not cut neatlyCause Corrective ActionThe paper is bent or curled at the cut position. Straighten out any curling by the edges of the paper.Paper rises by the ends of the cut position be-fore it is cut.Reload the paper correctly.You are using paper that cannot be cut withthe Cutter Unit.Specify Manual in Cutting Mode in the Control Panel menu and usescissors or a cutting tool to cut the roll after printing.(See "Specifying the Cutting Method for Rolls.") →P.586Cut Speed is not configured correctly in theControl Panel menu.Change the Cut Speed setting in the Control Panel menu.(See "Menu Structure.") →P.645During cutting, printed documents fall out atan angle.In the Control Panel menu, set Cutting Mode to Eject. Hold docu-ments after printing, as they are cut.(See "Specifying the Cutting Method for Rolls.") →P.586Paper is not cutCause Corrective ActionIn the printer driver, No or Print Cut Guideline isspecified in Auto Cut.Specify Yes in Auto Cut in the printer driver.In the Control Panel menu, Cutting Mode is set toEject or Manual.If the Cutting Mode is Eject, press the Cut button to cut the pa-per.If the Cutting Mode is Manual, cut rolls with scissors or thelike.Troubleshooting > Problems Regarding Paper >Roll paper cannot be inserted into the paper feed slot iPF65011766
