Cause Corrective ActionWhen Detect Mismatch in the Control Panel menuis set to Pause or Warning, the width of the loa-ded roll does not match the width specified in FitRoll Paper Width in the printer driver.Make sure the roll width selected in the dialog box displayedwhen you select Fit Roll Paper Width in the printer drivermatches the width of the roll loaded in the printer, and then tryprinting again.Paper size not detected.Cause Corrective ActionPaper has been loaded askew, or warped paper has been loaded. Follow these steps to reload the roll.1. Push the Release Lever back.2. Adjust the right edge of the roll to make itparallel to the orange Paper Alignment Line.3. Pull the Release Lever forward.4. If "Not finished printing. Finish printingremaining jobs?" is shown on the DisplayScreen, press the OK button.Printing will resume, starting from the pageon which the error occurred.(See "Loading Rolls in the Printer.")→P.572If this error recurs after you reload the roll, re-move the Roll Holder from the printer, push theroll firmly in until it touches the Roll Holderflange, and reload the Roll Holder in the print-er.(See "Attaching the Roll Holder to Rolls.")→P.568Follow these step to reload a sheet.1. Push the Release Lever back.2. Load the sheet, aligning it with the guide onthe right.3. Pull the Release Lever forward.4. If "Not finished printing. Finish printingremaining jobs?" is shown on the DisplayScreen, press the OK button.Printing will resume, starting from the pageon which the error occurred.(See "Loading Sheets in the Printer.")→P.594Because the Platen is soiled with ink or other substances, the size ofthe clear film cannot be detected.Open the Top Cover and clean the entire Plat-en.(See "Cleaning Inside the Top Cover.")→P.744Error Message > Messages regarding paper >Paper size not detected. iPF65012798
