Cause Corrective ActionThe paper has come out of the printer. 1. Remove the paper and press the OK button.2. Reload the sheet, aligning it with the guide on the right.(See "Loading Sheets in the Printer.") →P.594Follow these step to reload a sheet.1. Push the Release Lever back and remove the paper.2. Pull the Release Lever forward.3. Reload the sheet, aligning it with the guide on the right.(See "Loading Sheets in the Printer.") →P.594Paper cutting failed.Cause Corrective ActionThere are sheets left on theEjection Guide.1. Push the Release Lever back and remove the paper.2. Load the paper.3. Pull the Release Lever forward.4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Dis-play Screen, press the OK button.Printing will resume, starting from the page on which the error occurred.(See "Loading Rolls in the Printer.") →P.572There is a foreign object bythe Output Tray, obstruct-ing the Cutter Unit.1. Lift the Top Cover and remove the foreign object.2. If "Not finished printing. Finish printing remaining jobs?" is shown on the Dis-play Screen, press the OK button.Printing will resume, starting from the page on which the error occurred.You are not using the print-er under the recommendedenvironmental conditionsfor the paper.Use the printer only where the recommended environmental conditions for the paper aremet. Note that various environmental conditions are recommended for various types ofpaper. For details on the recommended environmental conditions for paper, see PaperReference Guide."(See "Types of Paper.") →P.562You are using paper that isnot compatible with auto-matic cutting.1. Specify Manual as the cutting method and use scissors or a cutting tool to cut theroll.(See "Specifying the Cutting Method for Rolls.") →P.586For information about paper that is compatible with automatic cutting, see the PaperReference Guide.(See "Types of Paper.") →P.5622. Push the Release Lever back and remove the paper.In other cases, the CutterUnit may be damaged.Contact your Canon dealer for assistance.End of paper feed.Cause Corrective ActionYou are pressing the ▲ button on the Control Panel and trying to rewind the roll to the edge. Release the ▲ button.Error Message > Messages regarding paper >iPF650 Paper cutting failed.12803
