Configuring the Printer's NetWare Network SettingsFollow the steps below to configure the NetWare network settings.1. Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUIpage.http://printer IP address or name/Example: http://xxx.xxx.xxx.xxx/2. Select Administrator Mode and click Logon.3. If a password has been set on the printer, enter the password.4. Click Network in the Device Manager menu at left to display the Network page.5. Click Edit in the upper-right corner of the NetWare group to display the Edit NetWare Protocol Settings page.6. Refer to the NetWare Settings Items table to complete the settings.NetWare Settings ItemsItem Details DefaultSettingFrame Type Specify the type of frame to use in NetWare. DisabledNCP Burst Mode Activate this setting to use NCP Burst Mode.This mode supports fast data transfer when printing in queue servermode. Normally, leave the setting On.OnPrint Application Choose the print service.• Bindery PServer• RPrinter• NDS PServer• NPrinterNDS PSer-verPacket Signature Select If Requested by Server to use packet signature. If Reques-ted byServerBinderyPServerFile Server Name Specify the name of a file server that has a NetWare print server.(0–47 characters)—Print ServerNameSpecify the name of a NetWare print server.(0–47 characters)—Print ServerPasswordSet a password for the print server.(0–20 characters)—Polling Interval Specify the interval to confirm jobs.(1–15 seconds)5RPrinter Print ServerNameSpecify the name of a NetWare print server.(0–47 characters)—Printer Number Specify the number of the printer connected to the NetWare printserver.(0–15)0Network Setting > Network Setting (Windows) >iPF650 Configuring the Printer's NetWare Network Settings9701
