Network Setting (Mac OS X)Configuring the Printer Driver Destination ...................................................................................................... 711Configuring the Printer's AppleTalk Network Settings ..................................................................................... 711Configuring the Destination for AppleTalk Networks ...................................................................................... 712Configuring the Destination in TCP/IP Networks ............................................................................................ 714Configuring the Destination for Bonjour Network ........................................................................................... 716Configuring the Printer Driver DestinationSpecify the printer driver destination as follows if the printer's IP address is changed, or if you will use the printer over anetwork connection instead of via USB connection.• If you switch to printing in a TCP/IP network, or if the printer's IP address is changed, see "Configuring the Destina-tion in TCP/IP Networks ." →P.714• If you switch to printing in a Bonjour network, see "Configuring the Destination for Bonjour Network ." →P.716Configuring the Printer's AppleTalk Network SettingsFollow the steps below to configure the AppleTalk network settings.1. Start the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUIpage.http://printer IP address or name/Example: http://xxx.xxx.xxx.xxx/2. Select Administrator Mode and click Logon.3. If a password has been set on the printer, enter the password.4. Click Network in the Device Manager menu at left to display the Network page.5. Click Edit in the upper-right corner of the AppleTalk group to display the Edit AppleTalk Protocol Settings page.6. Refer to the AppleTalk Settings Items table to complete the settings.AppleTalk Settings ItemsItem Details Default SettingPhaseTypeSpecify whether to use AppleTalk.If you will use AppleTalk, choose Phase 2.If you will not use AppleTalk, choose Disabled.DisabledName(*1)Specify the object name used by AppleTalk (in up to 31 single-byte or 15 double-byte characters).However, do not use the following single-byte characters: @, *, :, and =.CanonNB-18GB(xxxxxx)Zone (*2) Specify the printer zone name, up to 31 single-byte characters.However, do not use the following single-byte characters: Also avoid using * (whichrepresents the default zone) in the middle of a string.*Network Setting > Network Setting (Mac OS X) >iPF650 Configuring the Printer Driver Destination9711
