Canon imagePROGRAF iPF650 User Manual

Also see for iPF650 - imagePROGRAF Color Inkjet Printer: Brochure & specs Install guide Basic guide Basic guide Brochure

Contents

Canon imagePROGRAF iPF650 User Manual Manual pdf 607 page image

2. Press the ▼ button to advance the roll to the position for cutting.3. Press the Cut button.4. Press ▲ or ▼ to select Yes, and then press the OK button.After the roll paper is cut, it is rewound automatically.Caution• If paper would be short when cut at a particular position, the roll may automatically be advanced insome cases before cutting.Cutting the Leading Edge of Roll Paper AutomaticallyIf the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this case, set TrimEdge First to Automatic or On in the Paper Menu on the Control Panel to have the printer cut the leading edge to makethe edge straight after you load a roll.Trim Edge First offers the following options.• AutomaticIf the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 3 mm (0.12 in) or more when youload the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and scraps are removed. The edgeis not cut if the unevenness is less than 3 mm. However, paper may sometimes be cut, depending on the state of theleading edge.• OffThe edge is not cut and scraps are not removed. This setting is Off for most types of paper, by default. For more infor-mation, see the Paper Reference Guide. (See "Types of Paper.") →P.562Handling Paper > Handling rolls >iPF650 Cutting the Leading Edge of Roll Paper Automatically6591