Messages regarding printheadsCannot adjust printhead. ................................................................................................................................. 810Wrong printhead. ............................................................................................................................................. 810Printhead error ................................................................................................................................................ 810No printhead .................................................................................................................................................... 811Execute printhead cleaning. ............................................................................................................................ 811Cannot adjust printhead.Cause Corrective ActionThe Printhead noz-zles are clogged.Execute Head Posi. Adj. again, as follows.1. Press the OK button to clear the error.2. Print a test pattern to check the nozzles.(See "Checking for Nozzle Clogging.") →P.7283. Clean the Printhead if the nozzles are clogged.(See "Cleaning the Printhead.") →P.7294. Execute Head Posi. Adj. again.(See "Automatic Adjustment to Straighten Lines and Colors (Head Posi. Adj.).")→P.607The Printhead can-not be aligned; high-ly transparent film isloaded.Press the OK button to clear the error.We recommend using a type of paper that you often use, other than film, for Printhead adjust-ment.(See "Automatic Adjustment to Straighten Lines and Colors (Head Posi. Adj.).") →P.607The Printhead is in-stalled crooked.Straighten the Printhead as follows, and then execute Head Posi. Adj. again.1. Press the OK button to clear the error.2. Use Head Inc. Adj. to adjust the angle of inclination of the Printhead.(See "Adjusting Line Misalignment (Head Inc. Adj.).") →P.6113. Execute Head Posi. Adj. again.(See "Automatic Adjustment to Straighten Lines and Colors (Head Posi. Adj.).")→P.607Wrong printhead.Cause Corrective ActionAn incompatible Printhead has been installed. Open the Top Cover and replace the Printhead with a new one.(See "Replacing the Printhead.") →P.730Printhead errorCause Corrective ActionThere is a problem with the Printhead. Open the Top Cover and replace the Printhead with a new one.(See "Replacing the Printhead.") →P.730Error Message > Messages regarding printheads >Cannot adjust printhead. iPF65012810
