Insufficient paper for jobCause Corrective ActionThe printer has received a print job longer than the amount of roll paperleft when ManageRemainRoll in the Control Panel menu is On.Press ▲ or ▼ to select Print, and thenpress the OK button to resume printing.However, the roll paper may run out duringthe print job and you may not be able toprint all of the document.Press ▲ or ▼ to select Change Paper, andthen press the OK button to stop printing.Either change the printer driver PaperSource setting or the GL2 Settings > Pa-per Source setting in the printer menu orreplace the roll with a roll that has enoughpaper for the print job, and then try printingagain.(See "Removing the Roll from the Print-er.") →P.578(See "Loading Rolls in the Printer.")→P.572This paper cannot be used.Cause Corrective ActionPaper smaller than the printer's minimum suppor-ted size has been loaded.Push the Release Lever back and load paper of the correct size.(See "Paper Sizes.") →P.565Paper has been loaded that is too small to print thetest pattern for printhead adjustment or nozzlechecking.Push the Release Lever back and load unused paper of A4 size orlarger. More than one sheet may be required depending on the ad-justment.Roll printing is selected.Cause Corrective ActionYou have attempted to print a test print sheetor other printer status information on a roll,but no roll is loaded.Press ▲ or ▼ to select Load Roll Paper, and then press the OK but-ton. Load the roll, and then print.(See "Attaching the Roll Holder to Rolls.") →P.568(See "Loading Rolls in the Printer.") →P.572To print on sheets, follow these steps.1. Press ▲ or ▼ to select Stop Printing, and then press the OK but-ton to stop printing.2. Load a sheet and try printing again.(See "Loading and Printing on Sheets.") →P.6Error Message > Messages regarding paper >iPF650 Insufficient paper for job12799
