Item Details Default SettingLocation Enter the location where the device is installed.(0–32 characters)blankAdministrator Enter the administrator's name.(0–32 characters)blankPhone Enter the administrator's contact information.(0–32 characters)blankComments(E-mail) Enter any comments regarding the administrator.(0–32 characters)blankSecurity SettingsItem Details Default SettingNew Password Enter the new password.(0-9999999)blankConfirm Enter the new password again to confirm it.(0-9999999)blankOn the Security settings screen, besides entering a password, you can specify other security-related information,such as IP address-based SNMP or TCP usage restrictions, MAC address-based access restrictions, or IPP andFTP authentication settings.7. Click OK to activate the settings.Configuring the Communication Mode ManuallyThis topic gives instructions for configuring the communication mode manually.1. On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab ( ).Note• If the Tab Selection screen is not displayed, press the Menu button.2. Press the OK button.The Set./Adj. Menu is displayed.3. Press ▲ or ▼ to select Interface Setup, and then press the OK button.4. Press ▲ or ▼ to select Ethernet Driver, and then press the OK button.5. Press ▲ or ▼ to select Auto Detect, and then press the OK button.Network Setting > Network Setting >iPF650 Configuring the Communication Mode Manually9697
