Chapter 33-159F-3-1030Make sure that all cables on the fixing film unit are hooked into the fixingseparation guide when reassembling the guide. Especially the right-side ca-bles are easy to be pinched unless properlyhooked into the guide.F-3-103116) Lift the fixing film unit [1] up straight in horizontal position to take it outof the fixing unit.F-3-10323.7.3.4 Removing the Fixing Pressure Roller 0011-75641) Remove the pressure roller[1] from the fixing unit.F-3-10333.7.4 Fixing Delivery Paper Sensor3.7.4.1 Removing the Fixing Assembly 0011-78561) Turn the lever [1] of the fixing assembly 90 deg in the direction of thearrow.2) While holding the grip [2], slide out the fixing assembly [3] toward thefront and out of the machine.Whenever you have to replace the fixing assembly, be sure to disconnect thepower cord first. Also, be sure to wait unit the fixing assembly has cooledbefore removing it after disconnecting the power cord.F-3-10343.7.4.2 Removing the Face-Up Cover 0011-78571) Turn the fixing lever [1] of the fixing assembly 90 deg in the direction ofthe arrow.2) Remove the 4 claws [2], and detach the face-up cover [3] from the fixingassembly.F-3-10353.7.5 Pre-Fixing Paper Detection Sensor3.7.5.1 Removing the Rear Cover 0007-88851) Disconnect the cable [1] of the power supply assembly.2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.F-3-10363) Open the reader assembly [4], and lift to free the 2 claws [5].[1][2][1][2][1][1][1] [1][3] [2][1] [1][2][3][2][3][1][3]
