Chapter 33-158F-3-10234) Pressing the boss [1] inward, rotate the delivery idle gear shaft holder [2]in the direction of the arrow and remove the holder together with thedelivery idle gear shaft [3].F-3-10245) Remove the 4 screws [1]; then, remove the 2 claws [2] and the boss [3] todetach the fixing upper cover [4].F-3-1025Make sure that the 2 springs are fitted onto the bosses on the fixing uppercover when reassembling the cover. See the figure for the correct positionsof the boss and springs (shown on the left).F-3-10266) Remove the upper separation guide [1].7) Remove the 2 releasing levers [2].8) Slide the pressure plate [4] in upward direction, and remove the 2 bosses[3].9) Remove the pressure plate [4] from the fixing assembly.F-3-102710) Disconnect the connector [1], and free the cable [2] from the clamp [3].11) Remove the screw [4].F-3-102812) Remove the cable [1] from the guide [2].13) Remove the 2 claws [4], and disconnect the connector [3].14) Free the cable from the edge saddle [5].F-3-102915) Remove the 1 screw [1] and slide the fixing separation guide [2] out tothe left.[2][1][4] [3][5][1][2][3][1][1][2][3][4][1][2][1][2][2][3][3][4][4][1][3][2][4][1][2][2][4][3][3][5]
