Canon MF8100 Series Service Manual

Contents

Canon MF8100 Series Service Manual Manual pdf 204 page image

Chapter 33-114F-3-7443.5.10.11 Removing the Waste Toner Detection PCB 0007-88551) Disconnect the connector (J108) [1] of the DC controller box; then, freethe harness from the harness clamp [2].2) Remove the screw [3], and detach the waste toner detection PCB.F-3-7453.5.11 Developing Rotary/Toner Level Detection PCB3.5.11.1 Removing the Rear Cover 0007-85491) Disconnect the cable [1] of the power supply assembly.2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.F-3-7463) Open the reader assembly [4], and lift to free the 2 claws [5].F-3-7474) Close the reader assembly; then, detach the rear cover[1].F-3-7483.5.11.2 Removing the Reader Assembly 0007-85871) Open the reader assembly, and remove the left and right E-rings [1]; then,pull out the pin [2].F-3-749When closing the reader assembly, be sure to push in the arm [1] first.[1][1][2][2][3][2][1][1][2][2][2][3][4][2][3][1][3][4][5][2][3][1][3][2][1][2][1]