Chapter 33-109F-3-7113.5.8.8 Removing the Inside Cover 0007-88601) Remove the 2 claws [1], and detach the inside cover [2].F-3-7123.5.8.9 Removing the ITB Home Position Detection PCB0007-88611) Remove the test print switch lever [1].2) Remove the screw [2], and disconnect the connector [3]; then, detach theITB home position detection PCB [4].F-3-7133.5.9 Transfer Charging Roller3.5.9.1 Removing the Transfer Charging Roller 0007-71291) Open the reader assembly [1] and the top cover [2].F-3-7142) Remove the 2 screws [1], and detach the transfer inlet guide [2].F-3-7153) Remove the 2 claws [1] of the left and right bushings; then, detach thetransfer charging roller [2].F-3-7163) Remove the gear [1] and the bushing [2]; then, detach the transfercharging roller.F-3-717When replacing the transfer charging roller, be sure to hold it by its shaft [1]and its bushing [2]; be sure never to touch the sponge segment [3]. Also,when mounting the transfer charging roller, be sure that the spring is securelyfitted to the boss of the bushing so that the bushing pushes the spring.[1][2][1][2][1][2][3][4][1][2][1][2][2][1][2][1]
