Chapter 33-93F-3-610F-3-611When attaching the top cover, be sure to fit the link lever [2] while keepingthe drive release lever [1] in up position (i.e., with drive disengaged).F-3-612If you are fitting the drum cartridge in the machine with the top cover re-moved, be sure to do so with the drive release lever [1] fully in up position(i.e., with drive disengaged).If the drive release lever is in low position (i.e., with drive engaged), it forcesout the coupling [2], causing the coupling to interface with the drum car-tridge and to suffer damage.F-3-6133.5.4.8 Removing the Left Frame 0007-88111) Remove the 4 screws [1], and detach the left frame [2].F-3-6143.5.4.9 Removing the Shift Motor 0007-88801) Disconnect the connector [1], and remove the 2 screws [2].2) Slide the shift motor [3] in upward direction to detach.F-3-6153.5.5 Developing Rotary Motor3.5.5.1 Removing the Rear Cover 0007-85571) Disconnect the cable [1] of the power supply assembly.2) Open the face-up cover [2], and remove the 4 screws [3] of the rear cover.[1][2]OK NGEnlarged View of the Paper Retainer[3] [3][1][2][1][2][1][1][2][1][2][2][3]
