Chapter 33-24F-3-149When attaching the top cover, be sure to match its 2 positioners [1] and the2 cut-offs [2] of the face-down sub cover, while making sure that the paperretainer [3] is not blocking the feed path.F-3-150F-3-151When attaching the top cover, be sure to fit the link lever [2] while keepingthe drive release lever [1] in up position (i.e., with drive disengaged).F-3-152If you are fitting the drum cartridge in the machine with the top cover re-moved, be sure to do so with the drive release lever [1] fully in up position(i.e., with drive disengaged).If the drive release lever is in low position (i.e., with drive engaged), it forcesout the coupling [2], causing the coupling to interface with the drum car-tridge and to suffer damage.F-3-1533.2.12.8 Removing the Right Frame 0011-65891) Remove the 5 screws [1], and detach the right frame [2].F-3-1543.2.12.9 Removing the Shield Plate 0011-66111) Free the flat cable [1] from the connector.2) Remove the 6 screws [2], and detach the shielding plate [3].[4][1][1][2][3][1][2]OK NGEnlarged View of the Paper Retainer[3] [3][1][2][1][2][1][1][2]
